1.800.880.4808
APEC WATER
Products Filters Parts F.A.Q.s Promotions My Account View Cart
Reverse Osmosis Technlogy Water Education
& Your Health
Customer Reviews
& Testimonials
Talk to a WQA Certified
Water Specialist
 

APEC RO-CTOP System: Faucet Adaptor Kit Replacement

To replace the faucet adaptor on your RO-CTOP system, please follow the instructions below:

  1. Remove faucet adaptor:  Unscrew and remove the feed water Faucet Adaptor from your faucet.
  2. Remove double-flex line from Stage-1 filter:  See Figure A below. 
    • To remove the flex line from the 1st-Stage filter, simply press in and keep holding down on the “gray” collet ring at the base of the gray plastic fitting, then pull to disconnect gray fitting from the filter tubing.
  3. Remove double-flex line from Flow-Restrictor:  See Figure B below. 
    • To remove the flex line from the Flow-Restrictor marked “USA–>420”, do the same as above. Simply press in and keep holding down on the “gray” collet ring and pull to disconnect gray fitting from the flow-restrictor tubing.
  4. Connect new faucet adaptor to your RO system: 
    • Connect the Faucet Adaptor to your faucet as before. Each of the two elbows will be individually labeled.
    • Connect the double-flex lines to the1st-Stage filter and Flow-Restrictor. Do so by simply pushing the “gray” fitting tightly into the filter tubing. Do not add anything to the connection. No Teflon tape needed here. These are “Quick-Connect” type fittings, just push the fitting into the receiving line tightly, and a secure connection will be made.

Now your RO system is ready to be used again. 

 

If the issue was not addressed, please contact us at:
800-880-4808, or
techsupport@freedrinkingwater.com

About Water Quality Specialist

Speak Your Mind

Tell us what you're thinking...
and oh, if you want a pic to show with your comment, go get a gravatar!

You must be logged in to post a comment.